|
| Heating tight mica collar |
Tight housing:
brass: up to 375 °C
Supply voltage 230 V
Orientation of the output: axial 45°
Electric connection by cable isolated silk from glass under flexible braid steel, length 400 mm
Tightening by screw
Wrap BRASS:
- maximum Temperature: 375 °C - Output: axial 45°
Applications:
- Transformation of the plastics, bakelites, epoxy, polyester, rubber
- Hot Moulds,…
Options:
- Another dimensional range (diameter, width, length and orientation of the cable)
- Another electric range (power, voltage)
- Another electric End fitting
- Another type of tightening |
|
|
| Heating collar for standardized barrel |
Element armoured stainless steel AISI 321 covered with a framework out of galvanized steel insulated mica (nontight construction)
Composition: 2 half collars
Tightening by reductions
Dimensions: height 120 mm, Ø int. 580 mm
Power: 2 X 650 W
Specific charge: 0,64 W/cm2
Power 230 V
Precautions for use:
- Place the collar low possible by taking care that this one marries the shapes of the barrel as well as possible
- Check that the level of the liquid is higher than the site of the collar. In the case of variations of level in your process, plan controllers of level
- Check that the acceptable maximum temperature by the liquid cannot be exceeded or insert a thermostat
- Not to cover the barrel at the time it heating in order to to avoid an increase in the pressure or insert a pressure controller |
|
|
|
platinum rtd (pt100) probes
Cliquez pour afficher la liste complète
